Troubleshooting - Smeg KLVS50EB Instruction Manual

2. Troubleshooting

The dishwasher is equipped with a self-diagnostics system that is capable of detecting and
signalling a number of possible faults.
TABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEM
FAULT
E1
The anti-flooding system (where present) has been tripped.
E2 - E9
The water level limitation system has tripped.
E3
The appliance cannot heat the water.
E4
The temperature sensor is disconnected.
E5
The appliance cannot take in the water.
E6
The appliance cannot drain the water from the tank.
E7
The dishwasher cannot measure the precise water quantity that has been loaded.
E8
Problem on the water distribution system to the baskets.
The E1, E2, E3, E4, E8, E9 alarms provoke the "forcing" to end cycle of the running program.
•
• The E5, E6 alarms interrupts the running program once the cause is resolved, it will bring bach
the execution of the program.
• The alarm E7 is visualized at the end of the cycle that comes, however, brought to the end
since the operation of the dishwasher is not harmed.
To "reset" an alarm is necessary:
Open and close the door, or turn off and on the machine. At this point is possible to program
•
the dishwasher again.
If the malfunction persists, contact your authorised Service Centre.
User instructions
DESCRIPTION