Mounting; Indoor Vs . Outdoor Installation; Conduit Openings - Joslyn JSP Series Installation, Operation And Maintenance Manual

JOSLYN JSP , JSPR INSTALLATION, OPERATION AND MAINTENANCE MANUAL
® TM

Mounting

JSP)
(
Mounting
JSPR)
(
Indoor vs. Outdoor Installations

Conduit Openings

(JSP)
tnbpowersolutions.com/joslynsurge
Mount the JSP to the building structure using construction methods and
hardware appropriate for your site . Install the conduit and pull the conductors
as specified in Table 2 .
Mount the JSPR to the building structure using construction methods and
hardware appropriate for your site .
Mount the JSPR into the wall . Electrician can mount to the back wall, if the
back wall is made of structural material such as masonry or plywood . (Drywall
is not a structural material) . If back wall is not made of structural material, the
electrician can create brackets to hold the SPD to the adjacent studs .
After the drywall has been installed, install Flush Mounting Plate (FMP) by first
removing the JSPR enclosure lid . Place the FMP over enclosed body . Attached
the FMP to the wall using the enclosed hardware kit . Screw the lid back on to
the enclosure body .
13"
11"
JSPR 120, 160 Weight: 30 lbs . (13 .6 kg)
NEMA 4 enclosures are suitable for indoor or outdoor use . NEMA 4X (stainless
steel) enclosures are suitable for corrosive environments as well . For direct
sunlight applications, Joslyn suggests shading the monitoring components .
All conduits and fittings must be rated and properly installed so that the final
installation maintains the NEMA rating .
If desired, punch holes at this time for the conduit or nipple or wait until
the JSP unit is mounted to the building structure . Punch holes only in the
designated areas as shown in the following illustration .
8