Chassis; Replacing Kerb Climber (L-Shape Lever) - Invacare Bora XTR Service Manual

A Power module
B Lighting PCB (optional)
E G-Trac sensor (optional)
For older power modules see corresponding controls
manual or earlier revision of this manual.
Powered Tilt
C Tilt actuator
Lifter
D Lifter actuator
Operation Hour Counter (Optional)
1528338-Q
F Operation hour counter
The optional operation hour counter is mounted laterally
on the frame.

5.6 Chassis

5.6.1 Replacing Kerb Climber (L-Shape Lever)

CAUTION!
Risk of crushing
Injury hazard to hands. The gas spring is under
pressure.
– Be careful with your hands.
– Use suitable tools.
• 3 mm Allen key
• 6 mm Allen key
• 8 mm wrench
• 17 mm wrench
• Pliers
• Oblong wooden block (approx. 14 x 14 x 30 cm)
When removing, take care of small parts such as
screws and washers. Put all small parts down so
that they can be installed in correct sequence.
Removing Kerb Climber
1. Secure mobility device against rolling away.
2. If necessary, remove parts that are in the way like
legrests or swinging axle.
3. Loosen and remove screw D.
4. Pull gas spring C out of holder.
5. Loosen and remove nut F including washer G.
6. Pull bolt A out of holder.
7. Remove switch lever B including bushing K, gas
spring C, washer J and nut H.
8. If needed, loosen and remove nut H including washer
J and replace gas spring C.
Service
17