Thorn WeatherForce LED Installation Instructions

Installation Instructions
Warning
Please read these instructions carefully before installation or lamp
replacement. Warranty of this product is subject to installation
and maintenance being carried using appropriate conventional
practices and/or any specific instructions enclosed within.
Installation must be carried out by a qualified electrician in
accordance with local wiring regulations. Ensure that the rated
voltage and frequency of the luminaire are compatible with the
electrical supply.
Disconnect mains power supply before installing, servicing or
maintaining the luminaire.
Changes to specification
The right is reserved to change the design and/or specification
without prior notice or public announcement.
Product application
This strong impact resistant product is made from Polycarbonate.
This material is ideal in waterproof & industrial applications.
However, it is not suitable for use in areas prone to contact with
solvents, detergents, oil, alkalis, organic chemicals, animal fats &
industrial cleaners.
Please contact your local Thorn office for suitable alternative
products to suit the above applications
Suspended Mounting
600mm Single
416mm
600mm Twin
1200mm Single
880mm
1200mm Twin
1. Remove the diffuser and gear tray
To install, remove diffuser, detach gear tray and maintenance suspension devices.
WeatherForce LED
Specification
This luminaire is designed to comply with
the requirements of AS/NZS 60598.
Supply Voltage: 240v ~ 50Hz
Classification For Protection: Against electric shock:
Class 1 earthed metalwork. This luminaire must be earthed.
IP Rating: 65 - A 6-10mm Ø, circular electrical supply
cable must be used to maintain the IP rating.
Maximum ambient operating temperature:
Up to Ta: 25�C
Direct Mounting
507mm
980mm
Installation positions and IP rating
IP65
IP65
Remove Screws
IP65
IP65 IP65
IP65 IP65