Table of Contents
Advertisement
MAINTAIN FLOOR TOOLS
CHECKING Rotating Floor Brush and Drive Belt
You should check your vacuum cleaners rotating floor brush and drive belt regularly for
wear or damage. You should also clean the brush and brush ends of strings, hair, and
carpet fibers. These can wrap around the brush and hamper its ability to effectively clean
your carpet. Also remove any debris that has accumulated under the brush cover.
1. Unplug cleaner from electrical outlet.
2. Place handle in low position and turn vacuum cleaner over
so bottom side is up.
3. Remove the six screws as shown with a screwdriver.
4. Remove the brush cover from the floor brush.
5. Grasp rotating floor brush at both ends and lift.
6. Clean string, hair and other debris from rotating floor brush,
paying particular attention to brush ends.
7. Clean string, hair and other debris from motor pulley and
drive belt areas.
8. Check drive belt carefully for wear, cuts or stressed areas.
9. Check air passageway for obstructions. Remove debris
from this area.
Rotating floor brush could cause the fringe of a rug to
become tangled within cleaner.
CAUTION
Use caution and turn off the floor brush when
vacuuming throw rugs with fringe.
REPLACING Drive Belt
1. Unplug cleaner from electrical outlet.
2. With rotating floor brush removed from vacuum cleaner,
grasp old drive belt and remove from motor pulley.
Discard old drive belt.
3. Place new drive belt over motor pulley and stretch other
end over rotating floor brush in the space between the
bristles.
4. Place ends of rotating floor brush down into slots on sides
as shown.
5. T urn rotating floor brush by hand several times in
the direction of motor pulley. If properly installed, drive belt
will center itself on rotating brush crown.
6. Reposition brush cover and screws. Tighten screws securely.
PARQUET BRUSH (OPTION)
Vacuum dust in wide area at once.
•
Remove waste matter completely if
•
the inlet is blocked.
10_ maintain tools and filter
brush
Cover
Advertisement
Table of Contents
