Ansul R-102 Owner's Manual page 4

OWNER'S GUIDE
R-102 RESTAURANT FIRE SUPPRESSION SYSTEM
(Part No. 418127)
PAGE 4 REV. 04 2018-NOV-29
BEFORE RESUMING BUSINESS
1. Immediately after discharge, call your Authorized ANSUL
Distributor to inspect and recharge your Fire Suppression
System.
2. Have the Authorized ANSUL
cause of the system actuation.
3. Area must be cleaned up within 24 hours after discharge
using warm water and cleaning detergents.
CLEANUP PROCEDURES
Although there is no unusual cleanup procedure for ANSULEX
or ANSULEX LpH agents, due to the alkaline nature of these
agents, all agent should be cleaned from kitchen surfaces
within 24 hours after system discharge. The reaction from
the wet chemical agent on cooking grease or oil produces a
foamy bi-product that can be wiped up with a cloth or sponge.
The following procedures should be followed:
!
1. Before attempting any cleanup, make certain that all fuel
sources to the equipment to be cleaned have been shut off.
Make certain that the exhaust hood and all appliance elec-
trical controls have been de-energized to avoid any chance
of electrical shock resulting from the cleaning process or
from electrically conductive alkaline liquid agent and/or its
residue.
2. Make certain all surfaces to be cleaned have cooled down
to room temperature.
3. Do not use water to clean any appliances that contain
hot grease or cooking oils. Doing so may result in violent
steaming and/or spattering
Distributor determine the
®
CAUTION
1. The fire suppression system agent is non-toxic; however,
®
food product and cooking grease/oil that has come in
contact with the agent will no longer be suitable for
human consumption and should be discarded.
2. Sponge as much of the agent as possible using sponges
or clean rags. Dispose of these sponges or rags in a local
sanitary land fill site in accordance to local authorities.
Note: Wear rubber gloves during cleanup as sensitive
skin may become irritated. If the ANSULEX agent
or its residue comes in contact with skin or eyes,
flush thoroughly with clean water.
3. Using hot, soapy water and either a clean cloth or
sponge, wipe away all foamy residue and thoroughly
scrub all surfaces that have come in contact with the
agent.
Note: Wear rubber gloves during cleanup as sensitive
skin may become irritated. If the ANSULEX agent
or its residue comes in contact with skin or eyes,
flush thoroughly with clean water.
4. After thoroughly cleaning all affected surfaces, adequately
rinse and allow to completely dry before re-energizing the
equipment.
For repairs, parts and service of the ANSUL
contact your Authorized ANSUL
(at www.ansul.com: "Find A Distributor").
Safety Data Sheets (SDS) are available at www.ansul.com
Note: The converted values in this document are provided for dimensional
reference only and do not reflect an actual measurement.
ANSUL, ANSULEX, and the product names listed in this material are marks
and/or registered marks. Unauthorized use is strictly prohibited.
R-102 System,
®
Distributor
®