Bluetooth Mode - NAD C 658 Owner's Manual

OPERATION
USING C 658

BLUETOOTH MODE

Bluetooth mode defines the two roles of the C 658 as either Bluetooth
Receiver or Bluetooth Headphones.
Receiver: Audio stream is received from a Source on the same
Bluetooth network environment.
Headphones: Audio is streamed or sent to another device (Receiver)
on the same Bluetooth network environment.
IMPORTANT NOTES
• Both Bluetooth Receiver and Bluetooth Headphones modes are
accessible via BluOS App.
• Ensure that the Bluetooth antenna is connected to the BT antenna
terminal at the rear panel.
C 658 AS BLUETOOTH RECEIVER
Initiate pairing of your Bluetooth device with C 658 by following below
procedure.
1 Using your iOS or Android device, go to Settings – Bluetooth and then
scan for Bluetooth devices.
2 Look for the unique device ID of your C 658 in the available device list
of your Bluetooth device. Pair or connect your C 658 and Bluetooth
device.
3 Upon successful pairing of your Bluetooth device and the C 658, select
"Bluetooth" from the BluOS App navigation drawer to initiate Bluetooth
playback
IMPORTANT
• Select Bluetooth Headphones "Disconnect" (see below) in order to
switch from Bluetooth Headphones to Bluetooth Receiver mode.
• If pairing is not successful, select "Unpair" or "Forget device" from the
"Settings" menu of your Bluetooth device and try pairing again.
C 658 AS BLUETOOTH HEADPHONES
A CONNECT
1
2
3
Front panel display
18
BluOS App
IMPORTANT
There is no audio output at Audio PRE-OUT (Balanced and Single-
ended) if C 658 is at Bluetooth Headphones mode.
B DISCONNECT
BluOS App
OR
BluOS App