Dial Pointer Setting - Sony CFM-A50 Service Manual

Note : Follow the instaooation procedure in the numerical order given.
1
Attach TU worm to tuner chassis.
2
Attach needle, tighten needle spring using a bolt, then attach TU
LED board.
3 Rotate TU worm until needle stops at the stopper shown in Fig. A.
4
Mount PLATE BLIND and position it as shown in Fig. B.
5
Attach the band knob. Make sure that the projected part of the
tuner chassis fits as shown in Fig. C (the arrow).
6
Tighten idler gear, combine projected part of band knob and the
band slider so that they interlock, then mount to main board.
7
Mount VR gear to main board, then turn in the direction of the
arrow until it stops.
8
Fasten the TU gear to the TU chassis with the screw.
Chassis, TU
Downloaded from www.Manualslib.com

DIAL POINTER SETTING

Fig. A
Stopper
Main board
manuals search engine
SECTION 3
2 Pointer
Screw (+P 2.6x5)
Retainer, Pointer
Chassis, TU
TUN LED board
Fig. C
Screws (+BV 3x10)
Slieder, band
Screw (+BV 3x10)
6 Gear, idler
– 7 –
4 Plate, blind
Fig. B
5 Knob, band
1 Worm, TU
8 Gear, TU
Screw (+BV 3x10)
Screw (+B 2.6x5)
7 Gear, VR
3