Advertisement

Portable Air Conditioner - PA200 II
User Manual
[Revision 1.0 October 2018]
READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY
DAMAGE AND MAY VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by
this manual may vary in appearance, assembly, inclusions, specifications, description and packaging.
E&OE
© 2018 Carson

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PA200 II and is the answer not in the manual?

Questions and answers

norman davis
January 22, 2025

can the air conditioner vent tube be inserted into a chjmney cavity

1 comments:
Mr. Anderson
May 14, 2025

No, the vent tube of the Carson PA200 II air conditioner should not be inserted into a chimney cavity. The manual advises against installing the air conditioner in locations with flammable gas or liquids and emphasizes proper exhaust installation. A chimney cavity may pose safety risks and is not an approved installation location.

This answer is automatically generated

Subscribe to Our Youtube Channel

Summary of Contents for Carson PA200 II

  • Page 1 Portable Air Conditioner - PA200 II User Manual [Revision 1.0 October 2018] READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND MAY VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by this manual may vary in appearance, assembly, inclusions, specifications, description and packaging.
  • Page 2: Safety

    Portable Air Conditioner - PA200 II Safety Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or equipment or property damage if not understood or followed. Safety messages have the following symbols:...
  • Page 3 Portable Air Conditioner - PA200 II General Electrical Safety General Electrical Safety General Service Information • Inspect electrical equipment, extension • Electrically grounded equipment must • The equipment must be serviced or cords, power bars, and electrical fittings have an approved cord and plug and repaired at authorised service centres for damage or wear before each use.
  • Page 4: Safety Symbols

    Portable Air Conditioner - PA200 II Safety Symbols The product may have safety warning labels attached to it, explained below. Understand the symbols on your product and their meanings. If any stickers become unreadable, unattached etc, replace them. Flammable Material Hazard...
  • Page 5 Portable Air Conditioner - PA200 II Carbon-Monoxide Hazard Pull Hazard Slope / Fall Injury Hazard "Slam Dunk" Warning Do not use the product in Be aware that the product Be aware that using the Do NOT attempt "slam dunk" confined areas or without...
  • Page 6: Table Of Contents

    Portable Air Conditioner - PA200 II Table of Contents Safety ..............................2 Safety Symbols ............................4 Parts Identification ..........................7 Fittings List ..............................7 Assembly and Set-Up ........................8 Selecting Your Location ..........................8 Exhaust Pipe Assembly ..........................8 Window Kit Installation ..........................9 Installation Examples ..........................
  • Page 7: Parts Identification

    Portable Air Conditioner - PA200 II Parts Identification Name Name Guide strip Strainer Control panel Drainage outlet Inlet grid Power cord and plug Exhaust pipe Power cord storage hooks Corner wheel Exhaust outlets Handle Fittings List Extendable Hose length: 28 - 150cm Window Seal plate length: 90 - 130cm E&OE...
  • Page 8: Assembly And Set-Up

    Portable Air Conditioner - PA200 II Assembly and Set-Up Selecting Your Location Install the air-conditioner in a flat, dry location, allowing 50cm of space around the air-conditioner in all directions to allow for adequate circulation of air. Exhaust Pipe Assembly 1.
  • Page 9: Window Kit Installation

    Portable Air Conditioner - PA200 II 3. Connect the elongated joint of the exhaust pipe to the window seal plate. 4. Install the seal plate into the nearest window. Ensure there are no objects within 50cm of the window itself to allow the air exhaust to flow freely.
  • Page 10: Installation Examples

    Portable Air Conditioner - PA200 II Installation Examples Wall Mounted Exhaust Bow Alignment Incorrect Pipe Bending E&OE © 2018 Carson...
  • Page 11: Operation

    Portable Air Conditioner - PA200 II Operation Control Panel Function Buttons • POWER - Press this button to turn the air-conditioner ON or OFF. • MODE – While running or when a timer is set, this button can select between COOL, DEHUMIDIFY, FAN and HEAT modes.
  • Page 12: Remote Control

    Portable Air Conditioner - PA200 II Remote Control POWER: Press to turn air-conditioner ON/OFF. TIMER: press to set timer. TEMPERATURE CONVERSION: Swap from C° to F°. COOL: Press to select COOL mode. DEHUMIDIFY: Press to select DEHUMIDIFY mode. FAN: Press to select FAN mode.
  • Page 13: Operating Modes

    Portable Air Conditioner - PA200 II Operating Modes HEAT and COOL modes • While the air-conditioner is running or is in TIMER ON mode, press MODE to select the HEAT or COOL mode. The LED lights on the control panel will light up.
  • Page 14: Drainage

    Portable Air Conditioner - PA200 II Drainage • When COOL, DEHUMIDIFY or HEAT is run in humid weather, condensation will be produced. The Water Full alarm will be triggered when the water in the pan reaches a certain level. •...
  • Page 15: Maintenance

    Portable Air Conditioner - PA200 II Maintenance This air-conditioner is designed to give you dependable service for many years. This section will explain how to clean and care for the air-conditioner properly. Before performing any maintenance, please turn the air-conditioner off and unplug it.
  • Page 16: Error Codes

    Portable Air Conditioner - PA200 II Error Codes The air-conditioner is built with sensors that will detect issues before they cause a malfunction. If the following errors appear on the screen, please refer to the table below. Error Code Meaning...
  • Page 17: Specifications

    Portable Air Conditioner - PA200 II Specifications Model PA200 II Cooling Capacity 4.1kW (14000BTU) Noise level 55dB Refrigerant R410A Airflow Volume 350m³/h Power supply 240V/50Hz Power Plug 10Amp, Australian Standard E&OE © 2018 Carson...
  • Page 18 ©2018 Carson. All rights reserved. No part of this document, including descriptive content, concepts, ideas, diagrams or images may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying, scanning or recording, or any information storage and retrieval system,...

Table of Contents

Save PDF