2.2 Procedure for Hardware Installation
1. Decide Where to Place Your Wireless Broadband Router:
You can place your Wireless Broadband Router on a desk
or other flat surface, or you can mount it on a wall.
For optimal performance, place your Wireless Broadband
Router in the center of your office (or your home) in a
location that is away from any potential source of
interference, such as a metal wall or microwave oven.
This location must be close to power and
network connections.
2. Set up LAN connection:
a. Wired LAN connection: connect an Ethernet cable from
your computer's Ethernet port to one of the LAN ports
of this product.
b. Wireless LAN connection: make sure the antennae
are in a vertical position.
Figure 2-3 Setup of LAN and WAN connections for this product.
3. Set up WAN connection:
Connect an Ethernet cable from the WAN port
to your cable/xDSL modem or Ethernet backbone.
Figure 2-3 illustrates the WAN connection.
4. Power on:
By connecting the power cord to the power inlet
and turning the power switch on, this product will
automatically enter the self-test phase. When it is in the
self-test phase, the indicators M1 and M2 will be lighted
ON for about 10 seconds, and then M1 and M2 will
be flashed 3 times to indicate that the self-test
operation has finished. Finally, the M1 will be
continuously flashed once per second to indicate
that this product is in normal operation.