AEG MRC 4150 Instruction Manual page 62

English
62
Alarm Function
General Information
• You'd like to be woken up by radio? Set the correct volume and the station ahead
of time. The device switches on with the last set volume.
• When the alarm time is reached, a dot flashes next to
Setting of the Alarm (in standby mode)
You can set two alarm times. Proceed as follows:
1. Keep the AL1 / VOL − button pressed for approx. 3 seconds. The indicator begins
to flash.
2. Set the hours with the HOUR / TU – button and the minutes with the MIN / TU +
button.
3. Then use the AL1 / VOL − button to select how you want to be woken up. Select
from:
• Buzzer ( ):
A buzzer sounds when the alarm time is reached. The volume of the buzzer
cannot be adjusted.
• Last heard radio frequency ( ):
As soon as your set alarm time is shown, the radio switches on. The last tuned
FM station plays at the last set volume.
4. After you have made the setting, the selected alarm time flashes for ca. 3 seconds.
The alarm time is stored. Then the current time is displayed.
To set the second alarm time, repeat the above steps with the AL2 / VOL+ button.
NOTE:
• In case of an activated alarm time, a dot will light up at " / " and/or at
" / ".
• If you do not press a button within 4 seconds, the settings are accepted
automatically.
• The alarm function ends automatically after approx. 60 minutes and the device
switches off.
Turning off the Alarm
To shut the alarm signal off until the next day, press the ON / OFF button.
MRC4150_IM_new2
or and/or or .
20.04.16