Display Diagnostic Codes - Dometic WDCVL Installation & Operating Instructions Manual

DISPLAY DIAGNOSTIC CODES

Diagnostic Service Codes
E10
E11
E12
E21
E30
E31
E70
Codes E20, 33-40, 64-81, and all others NOT listed above are an internal fault that MUST be corrected by a qualifi ed
service professional. The appliance may NOT work or in a few cases will function but NOT fully as designed. Contact a
Dometic Corporation authorized service representative to repair the appliance.
Description
Water fi ll time exceeds 7
minutes.
There is excessive water
left in the unit during unit
standby or end of cycle.
The water level in the drum
exceeds the designed level.
In three minutes, the water
level doesn't drain with
pump started.
Door won't lock in three
tries.
Door won't unlock in three
tries.
Button stuck.
Appliance Action
Unit will close valves and
stop.
Unit will start pump with
door locked, valve closed,
and motor stopped.
Unit will start pump with
door locked, valve closed,
and motor stopped.
Unit will pause with pump
stopped, door unlocked if
water level is low enough.
Unit will stop.
Unit will stop.
No function.
19
User Corrections
Tap is not open. Check inlet
hose and fi lters.
Check outlet hose for fold-
ing, clogs and grey water tank
level. Run spin cycle to drain
water. Clean pump fi lter with
caution, prepare for large
amount of water that will drain.
Check outlet hose for fold-
ing, clogs and grey water tank
level. Run spin cycle to drain
water. Clean pump fi lter with
caution, prepare for large
amount of water that will drain.
Check outlet hose for fold-
ing, clogs and grey water tank
level. Run spin cycle to drain
water. Clean pump fi lter with
caution, prepare for large
amount of water that will drain.
Check for latch or door seal
blockage. Ensure door is
closed.
Continue original cycle to
completion. Allow appliance to
cool. Run a spin cycle.
Check the buttons. Restart
unit.