BTX Intelligent Fashion SmartConnect Manual page 3

O p e r a t i o n - C o n t i n u e d
Command Entry Formatting
[SmartConnect Address] [Motor Channel] [Command] [Transmission Time]
Example: 0105U;
01 = SmartConnect Address
05 = Motor Channel
U = Execute "UP" command
; = Semicolon marks the end of a comman
Note: Transmission Time is not used in this example, and is not required be default.
Several additional examples are below:
All motors UP (Channel 01 through 14):
Motor at Channel 1 UP:
Motor at Channel 5 DOWN:
Motors at Channel 10 and 14 STOP:
Motors at Channel 8 Travel to Position A &
Channel 9 Travel to Position B
Additional Notes:
• Uppercase and Lowercase letters can be used interchangeably
• If using the Transmission Time feature, any two digits in the command string after the
command code represents length of transmission. For example, if you use 0107U22;, this
means that the UP command for Channel 7 will be transmitted for 22 seconds
• Up to 7 successive commands can be entered in a single line of the control terminal at a time
• Channel 00 means all 14 channels should run
E l e c t r i c a l S p e c i f i c a t i o n s
Power
9 - 15V DC, 200mA
20mA draw for each SmartConnect
Frequency
433.92 MHz
*Motor must be in Programming Mode
**Motor must be in Pairing Mode
***Only applies to Tumo Drapery motors. Motor must be in Programming Mode.
BTX Window Automation - 2016 Smar tConnect Instructions
© 2016 BTX Intelligent Fashion, LLC
(800) 422-8839 | www.btxinc.com
B T X S m a r t C o n n e c t
0100U;
0101U;
0105D;
0110S;0114S;
0108A;0109B;
3