Compliance Information - Recon JET Owner's Manual

COMPLIANCE INFORMATION

FCC Compliance Class B Digital Device
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
FCC Declaration of Conformity
Jet (FCC ID: ZW5009) comply with FCC standard CRF 47 Part 15
subpart B and subpart C – section 15.249. Operation is subject to
the following two conditions:
The RCM indicates a device's compliance
with applicable ACMA (Australian
Communications and Media Authority)
technical standards-that is, for
telecommunications, radiocommunications, EMC and EME-
and with applicable state and territory electrical equipment
safety requirements.
• This device may not cause harmful interference, and
• This device must accept any interference received, including
interference that may cause undesired operation.
Industry Canada Compliance
Jet was certified with IC numbers 9717A-009. This
device complies with Industry Canada license
exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the
device.
Cet appareil est conforme avec les normes de l'Industrie Canada-
sans les standards RSS (s). L'utilisation est soumise aux deux
conditionssuivantes: (1) cet appareil ne peut pas provoquer
d'interférences et (2) cet appareil doit accepter toute interférence,
y compris les interférences qui peuvent causer un mauvais
fonctionnement de l'appareil.
Japanese Radio Law and Japanese Business
Law Compliance
Jet (R: 202-SMC093, T: D 14-0053 202) is
granted pursuant to the Japanese Radio Law
(ordinance of MPT No. 37,1981) and the
Japanese Business Law (Article 56, Paragraph
1).
18