Lens; Nose Piece - Recon JET Owner's Manual

LENS

REMOVE THE LENS
1. Remove Jet's engine and battery before removing the lens. (See page. xx).
2. Found at the center of Jet's frame there is a tab. Insert your fingernail into
the slit found on top of the tab to open the lens release mechanism.
3. Gently pull the release mechanism back, approximately 5mm (1/4 inch) to
release the pin that holds the lens into Jet's frame.
4. Grasp the center of the Jet frame (not the sides) with one hand. With the
other hand, grasp the nose pads and nose bridge and then pull straight
down to remove the lens from Jet's frame.
REPLACE THE LENS
1. Make sure that Jet's lens release mechanism/pin is extended open.
2. Insert one side of the lens into Jet's frame. Follow this by pushing the other side of the lens into the
opposite side of Jet's frame.
3. Secure the lens by pushing the release mechanism/pin into the lock position – pushed into the frame.

NOSE PIECE

REMOVE THE NOSE PIECE
1. Grasp the lens by its edges with one hand.
2. With the other hand, grasp one side of the
nose bridge with your thumb and the
corresponding nose pad with your pointer
finger.
3. Rotate the nose piece down to release.
REPLACE THE NOSE PIECE
Align the nose piece with the center of bottom of Jet's
lens, and gently push it into place until it snaps in.
5