Table of Contents
Advertisement
Collision
COL
indication
LOOP
Loop indication Orange
Link/Act.
Link status
10/100M
100M
indication
Full Duplex
FDX
indication
2.1.2. Rear Panel
Ports
POWER Inlet
COM
PRINTER
Power Switch
2.2 Installation Requirements
The Barricade can be positioned at any convenient place in your office or home. No special
wiring or cooling requirements are needed. You should, however comply with the following
Orange
Green
Green
Orange
Function
Power inlet
Serial port (connect analog
modem or console cable)
Printer port
Power on/off
-7-
Transmission collisions have
On
occurred on the LAN
Loop connection has been
On
detected
On
The corresponding port is linked
The corresponding port is sending
Blinking
or receiving data
The corresponding port is
On
transmitting or receiving data in
100Mbps.
The corresponding port is
On
transmitting or receiving data in
full duplex mode.
AC 90V -230V/50-60Hz
9-pins D-type male connector
25-pins D-type female connector
Specification
On/Off
Advertisement
Table of Contents
