Linux 2.2.X Or Later Installation; Manual Loading And Configuration - SMC Networks SMC9462TX User Manual

1000 mbps gigabit ethernet pci network card

Table of Contents

NSTALLING AND

Linux 2.2.X or Later Installation

This section describes the procedure for manual and automatic

loading and configuration of the EZ Card 1000 Unix stream driver

for Linux 2.2.X or later. The Linux driver can be found in the

"\linux" directory on the SMC SuperDisk driver diskette.

Note: In the following sections that describe the driver

configuration it is suggested that these instructions be

carried out in a single-user environment.

1. Log into the Unix system as supervisor (root) and enter

Maintenance mode. Make sure that the current directory is "/"

using the Unix command "pwd."

2. Use the following steps to uncompress the package file:

# cd /tmp (and insert the floppy in the proper drive,

i.e. a:)

# mcopy a:/linux/2_2_X/smc9462t.o./temp

# cd temp

Now the installation directory is ready for use.

3. Load the EZ Card 1000 device driver module by simply running

the command:

# insmod smc9462t.o

You can also specify command line parameters for the driver,

such as:

#insmod MaxTxDesc=150 MaxRxDesc=150 RxBufSize=2048

The following command line parameters are supported:

2-10

ONFIGURING

ETWORK

RIVERS

Table of Contents

Do you have a question about the SMC9462TX and is the answer not in the manual?

Ez card1000