SERIES AIR CONDITIONERS. DAMAGE TO PRINTED CIRCUIT BOARD MAY RESULT. 2. COMPONENT MATCH-UP 6636 Series Package Air Conditioner. (Reference connectors. Both the thermostat supply and control specifications for model number breakdown and wiring can be quickly attached (plugged in) to the identification.)
5. GENERAL INFORMATION The 6636 series package air conditioners are intended only The air conditioner is powered by two separate 115 volt for installation by RV manufacturers. The units are for “off 20 AMP electrical services. the roof” installations and will usually be installed under the floor of the vehicle.
In order to improve installation time and reduce down time damaged by exposure to moisture. when servicing, RV Products recommends using drawer slides for mounting the air conditioner. Upon completion of the installation, verify that the air conditioner has a minimum clearance of 14"...
Do not drill or cut any openings drapes or bed sheets cannot block the into the air conditioner. opening; RV Products strongly recommends that all air distribution the consumer can gain easy access for systems be tested by the vehicle manufacturer in a floor servicing.
2 stage cooling unit. openings are referred to as the “power wire entries”. See Figure 1. RV Products On the terminal board, the termination point for both provides these two openings, each opening circuit 1 and 2 is equipped with two high-voltage is a 7/8"...
Page 9
Circuit 1 and 2 Origination Points BOX. MAKE SURE SHEATH CABLE IS CENTERED IN CLAMP BEFORE TIGHTENING IT. DO NOT OVER- When both cooling systems (stage 1 and 2) cannot be powered from a single shore line, then the system TIGHTEN!! THIS COULD RESULT IN PINCHING THROUGH THE PLASTIC must be wired as follows:...
REQUIREMENTS than purchasing the receptacle, the three pin connector can be The 6636 series air conditioner is designed to be operated cut from the wire ends, the wires stripped and spliced to from an RV Products electronic wall mounted thermostat.
Routing of the thermostat wiring harness must comply with THERMOSTAT MOUNTING all local and national electrical codes. Collect any excess thermostat harness in the air conditioner mounting Follow the instructions packed with the thermostat to select a location for thermostat mounting. Pay particular attention to compartment.
Page 12
RV Products A Division of Airxcel, Inc. P.O. Box 4020 Wichita, KS 67204 1976L118 (7-04) PP...