Advertisement
COD. SU7GOBIO/1.0
The default-programmed channel will be sending for the fingerprint used.
B) PUSHBUTTON ACTIVATION + BIOMETRIC VALIDATION OPERATING:
C) NORMAL TRANSMITTER OPERATING
If there are not fingerprints programmed in the device, this will operates as a normal transmitter pressing any of the
buttons.
If the fingerprint is not recognised, the orange led will be at ON and two beeps will be heard.
LOW BATTERY INDICATOR
At the time the protective cover is opened, the white and orange leds will be at ON and four beeps will be heard.
BIOMETRIC READER DAMAGED
At the time the protective cover is opened, the orange led will be at ON and one beep will be heard.
REPLACING THE BATTERY
Unscrew the screw in the rear part and replace the battery with the new one. Always use batteries of the same technical
data that ones supplied by the manufacturer to guarantee its durability.
RECOMMENDATIONS
How to pass the fingerprint correctly over the reader?
CORRECT
1.
Make sure finger is clean and dry. Place finger flat above the sensor strip with the top knuckle above the sensor.
2.
Swipe finger straight down keeping firm contact with the sensor. The swipe should be a slow, constant speed.
Special notes: Use the same finger for every swipe. It is important to swipe finger slowly and firmly as this is the reason
most swipes fall.
GOBIO
6
Advertisement
