Advertisement
4. Appliances Activatation Setup
A. Procedure:
a. Press & hold a key, punch Setup Button with a Setup Stick (punch – feel a click & let go), after
LED flash 3 times & off, use setup stick to punch the setup button again, & observe the LED blinking.
b.
The Sequence
of Blinking
Macro No.
C. As above table, press any key as LED blinking sequence no. indicates the macro you want to
assign. & it will confirm the assignment with blinking LED with times as the macro no. you've
choose. ex.: If the linked macro no. 7, is what you need; when the LED blinks the 7
on LS-330T panel, & the LED will blink 7 times to confirm the macro you've selected.
At last, the 3 LED will blink 2 times together to leave the setting mode.
- If you touch any key as the LED ON for 1 Sec., it means "Clear", no linked macro code assigned in
this setting.
- The setting cycle is once at a time, if you do nothing under setting mode. The system will be
recovery after LED blinks 10 times & constant ON for 1 Sec.
B. Control:
a.) Touch the key to send a Linked Macro Activating Code to a controller nearby, after it finished all
its preset 2-Way / Macro Control action.
b.)
Touch any key to break off the action as LC-X0T is transmitting actions.
Note:
1. This product should be programmed by RC-07.
2. Please contact the distributor near you to obtain correct/updating of product information.
3. Please refer to each manual of HC-12/RP-12/RP-10 for the details of scene (macro) setting.
Annex A：Panel Install / uninstall
[Uninstall]
Put the sucker on the marked spot, press to squeeze out air
& make sure the sucker is fixed, then pull out of the panel.
[Install]
There are 2 latches on the top of the panel, & a crystal in the
buttom. there is 2 slot for those 2 latches & a magnet for
crystal. PLS make sure the direction correctly. Slide latches
into slots first then press the crystal side into the magnet side
till the panel sink completely.
1st
2nd
3rd
4th
1
2
3
4
5th
6th
7th
8th
5
6
7
8
Constant ON
9th
10th
for 1 Sec.
9
10
Clear
th
, touch any key
Pull！
3
Advertisement
