Advertisement
LC-X0T Setting
※ Please see appendix for the details to take apart / dress up the front panel.
2. 2-Way SW Setup
A. Preparation:
Pre-set a Macro as a single action as [X], [ON] on a scene button of RC-07.
- [X] is the target light no. to be controlled as 2-Way; ex.: the target light no. is "3".
then we need to set a scence [3] [ON] in a scene button on RC-07.
(please refer to the user manual of RC-07 to obtain the detail setup procedures.)
B. Procedures
0. Practice to feel the press of the setup button with setup stick (A click)
1. Touch & hold a button & press the setup button (press & let go), LED flash 3 times means it's under
setting mode now. You have 7 sec. to input command by RC-07.
2. Pick up an RC-07, which has preset a scene, point its IR Digital Output to the Setup button, within 5cm
distance & 5 Sec. at least.
3. When the LED flash twice, it means the process is completed, please put away RC-07.
The 2-Way macro input is done.
4. Continue to set the next key or test the key function you've just set.
C. Control: Touch the key to control in 2-Way mode.
3. Scene Control Setup:
A. Preset a scene, which contains 36 actions or less;
(ex.: "Light no.1 – ON", "Light no.2 – ON"..., 36 actions are the most).
Follow the procedures as "2-Way Setup" to input this macro to any key of LC-X0T, to accomplish the setting.
B. Control: Touch a key to start a macro & touch any key to break off the action.
Sense Zones & DI key's Descriptions
2
Advertisement
