Advertisement
DROPOUT SYSTEM
YETI TIPS
Make sure your tools are in good condition.
A worn allen key can round the hex on a bolt
not allowing for proper torque.
Torque settings are listed throughout the
instructions. It is also import to prep all bolt
threads. The instructions denote whether to
use a blue Loctite compound or grease.
Warning: Service on Yeti bicycles requires special knowledge
and tools. Yeti Cycles recommends that all service and
repairs be performed by an authorized Yeti Dealer
TOOLS NEEDED
• 2.5mm allen key
• Blue loctite
01. 12MM X 142MM AXLE
The Shimano 12 x 142 axle nut allows you to
position the quick release lever for consistant,
easy wheel installation. Above are the parts you
will need ot set that position. Alxe nut, clocking
chip and chip retaining bolt.
03. CLOCKING CHIP INSTALL
To fit the clocking chip you may have to open the
lever and rotate the axle nut slightly. Once the
Axle nut is positioned properly place the clocking
chip into its recess . This piece will fit snugly and
will prevent the axle nut form rotating while the
axle is off the bike.
02. AXLE INSTALLATION
With you wheel in the frame and your derailleur
set up install the axle and nut. Close the lever to
proper tension and in the angle desired without
the clocking chip installed.
04. CLOCKING CHIP BOLT
Once the chip is in place install the retaining bolt
and you are all set. If you are having trouble
installing the bolt you may want to try adjusting
the Axle nut position slightly to allow the chip to
move into place.
*Apply blue Loctite
Advertisement
