AEG MPS 5693 Instruction Manual page 50

Manicure-pedicure-set
Hide thumbs Also See for MPS 5693:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 46
English
50
INSTRUCTIONS FOR USE
• This appliance is only intended for treating hands (manicure) and feet (pedicure).
• Do not use the appliance on cracked skin or open wounds!
• Do not use on birthmarks.
• Consult your doctor first in case of diabetes, haemophilia, or immunodeficiency.
• Regularly check the results during use in order to avoid injuries. This especially
applies for people with diabetes, since they are less sensitive to pain on hands and
feet.
• Excessive use can cause skin irritations. In such a case, stop using the appliance
until any redness has disappeared.
• Do not apply too much pressure. Guide the attachment with slight movements
around the spot to be treated.
• Always work very carefully!
• Pay attention to any accumulation of heat, e.g. when filing callus on feet. This
especially applies to people who are not sensitive to heat.
• Hard skin can be removed easily when dry. Do not remove the complete callus in
order to maintain the natural protection of the skin.
Water or skin lotions impair the progress of treatment. If necessary, briefly wash
your feet and then dry thoroughly.
NOTE:
To prevent the skin on your hand from cracking, apply a moisturising lotion after
treatment.
STARTUP OPERATION
1. Charge the rechargeable battery of the motor unit (see chapter "Charging the
Battery").
2. Attach the required attachment. Remove / attach the attachments by simply sliding
them off or onto the shaft of the motor unit.
CHARGING THE BATTERY
1. Turn the appliance off by putting the switch of the drive unit into the "0" position.
2. Take the mains adapter out of the storage compartment.
3. Connect the mains adapter to the connector of storage box.
4. Connect the mains adapter to a certified wall socket. Charge the appliance for
4 hours before first-time use.
MPS5693_IM
12.06.17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents