Charging The Battery - Razor HOVERTRAX 2.0 Owner's Manual

CHARGING THE BATTERY

Your Hovertrax 2.0 replacement battery may not be fully charged; therefore you must charge the battery
prior to use. Be sure to charge the battery in a clean, dry location away from direct sunlight, flames
or sparks.
• Use only Razor Hovertrax 2.0 charger
(not included).
• Initial charge time: 6 hours.
• Recharge time: up to 4 hours, even if the light
turns green. Recommended maximum charging
time is 24 hours.
• Always charge the battery immediately
after riding.
• Fully charge battery before storing for extended
periods of time.
• Unplug charger from the wall outlet when not
in use.
1
Plug the charger plug into wall outlet. The
light on the charger should be green.
Note: If green light (LED) does not turn on, try
a different outlet.
• Do not allow charger, dock or battery to overheat. If they seem warm, allow to cool down.
Charge only at room temperature.
• Do not place charger, dock or battery in the sun or warm environment. Keep at normal
room temperature
Model
Hovertrax 2.0
.
Voltage
(Nominal)
Vdc
36
• Failure to recharge battery periodically may
result in a battery that will not accept a charge.
• Do not charge at or below 32º F (0º C).
(Note: Charger design may vary from
one shown)
2
Plug the charger into the charger port on
the charging dock. The light on the charger
should turn red during charging. The light will
turn green again when charging is complete.
Capacity
(Nominal)
Temperature Range
Ah
2.5 0˚ to 40˚C
32˚ to 104˚F
2
LED
Charge
Temperature Range
Operating
-10˚ to 40˚C
14˚ to 104˚F