Husqvarna 365 X-Torq Workshop Manual page 48

4. Locate the guide pegs in the clutch side crankcase
half, grease and locate the gasket. See fi g. 12.
NOTE!
Continuing to pull with the assembly tool
after the gasket is clamped will damage the
crankshaft.
5. Use tool 502 50 30-14 and pull on the fl ywheel side
crankcase half. Pull until the gasket is clamped
between the two halves. See fi g. 13.
6. Insert the six bolts and tighten them in rotation.
Tighten them fi nally to 8 Nm. See fi g 14.
NOTE!
Ensure that excess gasket material does not
fall into the crankcase.
7. Cut off excess gasket at the level of the cylinder
seating plane.
8. Refi t the carburettor space bottom plate with the four
bolts. Tighten to 5 Nm.
9. Refi t the following components:
A. Tank unit.
B. Piston and cylinder.
C. Silencer.
D. Carburettor.
E. Lubrication system.
F. Centrifugal clutch.
G. Electrical system.
H. Recoil starter.
I. Chain and guide bar.
10. If a new crankshaft has been fi tted the saw must be
run in for 3-4 hours at the carburettor base settings.
46 – English
CRANKCASE AND CRANKSHAFT
Fig. 12
Fig. 13
Fig. 14