Subscribe to Our Youtube Channel
Summary of Contents for RFT Safe Place Mother Transmitter
- Page 1 Mother/Baby Match Mother Transmitter User Guide User Guide P/N: 0510-1020-A Released: 12/30/03...
- Page 2 Contents Preface............5 The MotherTransmitter..............5 Using the Mother Transmitter Fastening a Mother Transmitter.............6 Replacing a Mother Transmitter Clamp.........8 Cleaning and Caring for a Mother Transmitter......10 Testing a Mother Transmitter............12 Specifications...................13 Product Warranty................14 WARNINGS Use of non-approved cleaners and disinfectants on Transmitters may cause permanent damage to the Transmitter and the alarming band piercing contacts and will void any and all warranties.
- Page 3 KIND, WHETHER OR NOT FORESEEABLE OR IN CONTEMPLATION OF THE PARTIES, EVEN IF SELLER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. THIS WARRANTY IS THE ONLY WARRANTY APPLICABLE TO THE PRODUCT AND IS IN LIEU OF ANY OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
- Page 4 Product Warranty Important Information RF Technologies, Inc. (herein referred to as “Seller”), warrants to the Buyer that the RF Technologies, Inc. (Code Alert/Safe Place/Sensatec) System (herein referred to as It is important for your facility to implement and enforce the following “Product”) will be free from defects in material and workmanship for a period of one (1) guidelines in order to keep all equipment functioning properly.
- Page 5 Specifications Preface Introduction This guide provides detailed information about the Mother Transmitter. It provides e z i detailed instructions about using the component as well as specific requirements. The CA9450 Security System monitors doors, elevators, hallways, and stairwells, preventing the unauthorized exit of infants, children, or residents from a facility. The Mother/Baby Match system also identifies when a mother is given an whether or not it is her o l l baby.
- Page 6 Transmitter Tester will detect its signal, the indicator light will flash, and a tone will sound. To test a Mother Transmitter For more information about Code Alert or Safe Place products go to www.rft.com. For technical support, contact (800) 669-9946. For questions or comments about CA9450 Place the Transmitter Tester directly on the Mother Transmitter.
- Page 7 Wipe the Transmitter with a clean cloth or towel, and then allow the Transmitter to The Mother Transmitter air-dry. The transmitter may also be rinsed with water, if required in the manufacturer’s instructions. Introduction Inspect the alarming band piercing contacts on the Transmitter; the contacts should be gold in color and not bent or out of alignment.
- Page 8 Fastening a Mother Transmitter Cleaning and Caring for a Mother Transmitter This chapter provides detailed information about cleaning and caring for a Mother A Mother Transmitter is a small, yellow device placed on the wrist of a new mother. Transmitter. When it is activated, it sends a signal that is received by Exit Alarm Receivers and Alarming Band Receivers.
- Page 9 Place the Transmitter and alarming band onto the wrist of the mother. Replacing a Mother Transmitter Clamp Insert the alarming band material through the slot on the other side of the Mother Transmitter, from bottom to top. Again, guide the alarming band material through the slot at the top of the In some cases, it may be necessary to replace damaged Mother Transmitter clamps.
- Page 10 Modes. Follow your facility’s established procedures in the event of a mismatch. To program a Mother Transmitter without RFT banding material a i r Tap the transmitter 15 times within 6 seconds to clear or reset the transmitter.
Need help?
Do you have a question about the Safe Place Mother Transmitter and is the answer not in the manual?
Questions and answers