Mitsubishi Electric EHSC-VM6A Service Manual page 51

DISASSEMBLY PROCEDURE
4. How to swing the control box to the front
(1) Remove the front panel. (Refer to Procedure 1.)
(2) Remove the 2 screws from the 2 control box brackets (R).
(3) Remove the cable straps.
(4) Disengage the 2 control box brackets (R) from the right-
hand side panel and pull the control box. At this point,
lifting slightly and pulling the control box will swing the
control box to the front. (Photo 4-2)
Note: Remove the field wiring as necessary.
Photo 4-1
w The photos shown are of the EHSC model.
Photo 4-2
Control box
51
PHOTOS
Earth cable
Side panel
Cable straps
Swing
Screw
Brackets
(R)
Screw