Advertisement
Connecting to the power supply unit (PSU)
We recommend that you use the Labgear PSUFC – 12V 300mA PSU. If you consider using a
different power supply check its current rating against the specification table on page 2 to
ensure that it has sufficient capacity and note that poor quality power supplies can be a source
of noise that will affect your whole system.
The PSU should be placed on a solid non flammable surface in a well ventilated area.
DO NOT leave the PSU on a carpet or other soft furnishings or insulation material.
Take care to ensure that the PSU is not covered in any way that would prevent the free circulation
of air around it especially behind curtains or in loft spaces where insulation material is fitted.
Signal connections are made to the F connectors on the right-hand side of the power unit (see
Fig. 1 on page2).Good quality coaxial cable to EN50117-2 must be used. Labgear recommend
the use of CAI "benched marked" cable.
• The down lead from the masthead amplifier must be connected to the socket marked 'IN'.
• The signal output from the socket marked 'TV' is connected to the receiving installation
(satellite receiver, DVR, TV, etc.) or to the input of the cabled distribution system.
Connection to the PSU are made using F type (male) connectors. The use of high quality crimp
connectors is preferred. F type connectors should always be tightened very gently with a spanner.
Leaving them finger tight may result in unwanted signal ingress or leakage, as well as suck-outs
in the frequency response, alternatively do not over tighten as this could damage your PSU.
2 –Year Guarantee
Your amplifier is guaranteed against faulty components or poor workmanship for a period of
two years from the date of purchase. This guarantee does not cover accidental or malicious
damage (Including damage from natural causes such as lightning) and will be invalidated
by installation or use other than in accordance with these instructions, repair or attempted
repair other than by the manufacturer, or opening or removal of the case. This does not
affect your statutory rights.
Labgear Reserve the right to modify their designs or specifications, In the light of future
developments, without prior notice. Performance figures quoted are typical and subject to
normal manufacturing and service tolerances.
This product is intended for use within the UK and Eire.
Declaration of Conformity
Hereby, Labgear declares that this amplifier for TV broadcast reception in domestic premises is in
compliance with the Radio Equipment Directive 2014/53/EU.
The full Declaration of Conformity is available by contacting the following internet address: www.
labgear.co.uk/DoC
Technical Support
For further help, advice or information visit
Our website www.labgear.co.uk
Email: technical@labgear.co.uk
Bedford MK42 0NX
www.labgear.co.uk
4
Guarantee and Technical Support
Member
No. M. 1125
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority for
recycling advice.
© Philex Electronic Ltd. 2017 V1
COMPLIANT
Advertisement
