Wall Mounting Instructions; Mounting Notes - Ksenia lares series Installation Manual

Integrated platforms

Hide thumbs Also See for lares series:

User manual (12 pages)

Table Of Contents

Table of Contents

Available languages

1. Metal bottom

2. Large holes for passing cables

3. Bottom securing holes

4. System's board brackets

PC board brackets

auxi

6. Anti-tamper micro-switch

7. Micro-switch cable + connector

8. Earth connections on threaded pin and nut

9. Control panel board

10. Control panel micro-controller

11. Interconnection terminals

12. Programming USB connector

In order to correctly install the metal cabinet and the components inside it, please follow the instructions here below:

1. Fix the metal cabinet to the wall using Ø 0.32 inch screws (options)

In order to maintain the conformity with the listed norms at page 15, install a screw in correspondence to the tamper

2. Extract the support for power supply unit. (20)

3. Fix the power supply unit to its support using the provided M3 screws.

4. Place the support back.

5. Wire the cables as shown in picture.

6. Ensure the cables to the fixing holes (21).

• Arrange outside the Panel an isolating device (es. Circuit Breaker Device 16A Curve C).

• The two power supplies have respectively two internal fuses (25W - T2AL / 50W - F3.15AL).

In case should fail, its replacement requires the opening of the power supply and must therefore be carried

out by authorized personnel.

• Wire the earth connection directly on the power supply unit.

• The power supply conductors must be 0,6 inch.² minimum section.

MADE IN ITALY

A-BBBB

13. USB key (optional)

14. Power supply cable

15. 12V battery

16. Switching power supply unit

17. Battery terminals

18. Power supply unit terminals

19.

20. Support for power supply unit

21. Holes for cables fixing

22. 2A Fuse

23. ETHERNET connector