Advertisement
4. CHANGE THE OPERATION CODE FOR BOTH
TRANSMITTER AND RECEIVER (CONT)
3
If the connector is placed on the top and middle posts, that
column is set on " + " . If the connector is placed on the middle and
bottom posts, that column is set on " - ". If the connector is
removed completely, (not placed on any posts), it is set to " 0 ".
(see diagram for examples of how to
set a column to the three different
positions). When removing a con-
nector to set a column to " 0 ", save
the connector in case you change
the code at a later date.
4
After setting up the code connectors on the transmitter, you
are ready to set the same code on the receiver.
Remove the receiver from the electrical outlet before
changing the code.
WARNING
5
Remove the screw that holds
the connector cover, and remove
the cover.
You will see 10 connectors. For connectors "1" to "9", the
6
settings must match with those of the transmitter.
7
For connector "10" on the receiver, set the connector on "+" if
you are using button "1" to control this receiver. If you are
planning to use button "2" to control this receiver, you need to
remove this connector. See diagram below.
Connector 10 set to "+"
RECEIVER
Connector 10 "Removed"
RECEIVER
8
Put the cover and screw back onto the receiver. Plug the
receiver into an electrical outlet.
9
Put the battery cover back onto the transmitter.
10
Press the designated button on the transmitter to operate the
garage door.
'
'
0
'+'
Connectors
1 to 9 are
the same.
BATTERY
TRANSMITTER
Button 1- Left Button
TRANSMITTER
Button 2- Right button
12 volt alkaline battery (size 23A)
(included).
It is time to change the battery
when the red LED on the trans-
mitter does not turn on when
either button is pressed.
'-'
There are 2 buttons on your transmitter, the other button can be
used to control another Houselink
318R (sold separately) or Houselink
Model SW-318R (sold separately).
You can add as many additional transmitters as you want to
control the same receiver. Simply set the same operation
code on all transmitters with the same code setting on the
®
receiver. Houselink
318TN and Keyless Entry Transmitter Model 318K to work with
your receiver. For more information, please visit our website at
www.skylinkhome.com or contact us.
RISK OF ELECTRICAL SHOCK. FOR INDOOR USE ONLY.
CAUTION : DISCONNECT POWER BEFORE CODE CHANGING.
REPLACE COVER AFTER CODE CHANGING.
Maximum Rating:
Input : 120VAC 60Hz 2W
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
If, within one year from date of purchase, this product should become defective
(except battery), due to faulty workmanship or materials, it will be repaired or
replaced, without charge. Proof of purchase and a Return Authorization are required.
If you would like to order Skylink's products or have difficulty getting them to work,
please :
1. visit our FAQ website at www.skylinkhome.com, or
2. email us at support@skylinkhome.com (reply within 24 hrs), or
3. call our toll free at 1-800-304-1187 from Monday to Friday, 9 am to 5 pm EST.
Fax +800 286-1320
C U S T O M E R
S E R V I C E
Email:support@skylinkhome.com (Reply within 24 hrs)
http://www.skylinkhome.com
P/N. 101A206-002 Rev.2
US Patent. D380895
©2003 SKYLINK GROUP
5. BATTERY
6. ADDITIONAL RECEIVER
®
Garage Door Receiver Model
®
Wireless Switch Receiver
7. ADDITIONAL TRANSMITTER
offers Keychain Transmitter Model
8. CAUTION
9. FCC
10. WARRANTY
11. CUSTOMER SERVICE
Advertisement
