Advertisement
11
SPECIFICATIONS
Type
Model No.
ER-X001
Effective charge removal
50mm
width
0.3 second or
less (Note 1)
Charge removal time
0.5 second or
less (Note 2)
Ion balance
Discharge method
Discharge output voltage
Ozone generation
Maximum air pressure
Applicable fluid
0 to +50°C (ER-X001:0 to +40°C) (with no dew condensation)(Note7),
Ambient temperature
Ambient humidity
10 to 55Hz frequency (ER-X001:10 to 150Hz frequency), 0.75mm amplitude for 2
Vibration resistance
hours in each of XYZ directions (when the power is off)
Shock resistance
Resistance 100 m/s
Enclosure grounding method
Material
High-voltage cable length
1.2m
Approx.
Weight
370g
Notes: 1) In condition of discharge distance 50mm, center of the product, discharge wavelength 50Hz and air supply 60ℓ/min(0.3MPa).
2) In condition of discharge distance 50mm, center of the product, discharge wavelength 50Hz and no air supply.
3) In condition of discharge distance 100mm, center of the product, discharge wavelength 50Hz and no air supply.
4) Ion balance is average of plus and minus. Also, the specification value is typical value in condition of less
than ±10°C ambient temperature change, set the ion balance after 30 minutes of the discharge starting,
switching on the ion balance control function.
5) For ER-X001 the discharge frequencies of 50Hz, 20Hz are accepted. For ER-X008 and high-voltage cables
1m/2m, the discharge frequencies of 50Hz, 30Hz, 20Hz, 10Hz, 5Hz, and 1Hz are accepted. For other heads,
100Hz, 70Hz, 50Hz, 30Hz, 20Hz, 10Hz, 5Hz, and 1Hz are accepted.
6) The dried clean air is dried (dew point: equivalent of -20°C) and filtered (mesh-size: equivalent of 0.01μm) air.
7) The High and Low Temperature Resistant type of head (-60 to +200℃ ) are also available. Please contact us
for details.
8) Silicon needles type of head are also available. Please contact us for details.
9) High-voltage cables are also available in 1m and 2m lengths. Please contact us for details.
Type
Model No.
Number of charge removal
heads connected
Supply voltage
Current consumption
Indictor
DSC (Discharge)
Green LED [Lights up during discharge , blinking during discharge stopped.]
CHECK
Orange LED [Lights up when dirt, wear, etc. of the discharge needle is detected.]
ERROR
Red LED [Lights up when abnormal discharge is detected.]
Level meter
Green LED [5 levels, Lights up depending on amount of the charge or ion generation.]
Output
ALARM, ERROR
COM (COM OUT)
ALARM: ON when dirt or wear of the discharge needle is detected;
OFF when operation is normal.
Output operation
ERROR: OFF when abnormal discharge is detected;
ON when operation is normal.
Short-circuit operation
Intput
Discharge control input (DSC OFF)
COM（COM IN)
Input operation
Discharge allowed: Open. Discharge halt: 24V or 0V shorted.
Pollution level
Ambient temperature
0 to +50°C (with no dew condensation). For storage: -10 to +65°C
Ambient humidity
Operating altitude
AC 1000V, 1 minute, completely charged part/between enclosures
Voltage resistance
Insulation resistance
20 MΩ or more at DC 250V, completely charged part/between enclosures
10 to 150 Hz frequency, 0.75mm amplitude for 2 hours in each of XYZ directions
Vibration resistance
Shock resistance
Resistance 100 m/s
Over-voltage category
Enclosure grounding method
Material
Weight
Power supply / I/O connector: 1 set
Accessories
(Housing 5557-10R, terminal 5556TL [manufactured by Molex Inc.])
Ground wire approx. 3.7m: 1pc.
Notes: 1) Do not use or store the device in an environment where the air pressure is higher than the atmospheric pressure at an
altitude of 0 meters.
Type
Model No.
ER-XCCJ2H
Length
2m
Cable
Weight
Approx. 120g
12
OPTIONS (sold separately)
Model No.
ER-X001
Spare discharge needle unit
ER-XANT1
ER-XANT2
Discharge part protective
－
cover
AC adapter
Power cables
13
CE MARKED PRODUCT
● This product is CE marked product.
14
CSA/UL compliant product
● This product complies with CSA and UL standards, and has been certified by TUV SUD.
15
RoHS Directive
This product is in compliance with the RoHS Directive (EU).
Head
ER-X008
ER-X016
ER-X032
ER-X048
80mm
160mm
320mm
480mm
1 second or less (Note 3)
±30V or less (Note 2) (Note 3) (Note 4)
Pulse AC method (Note 5)
Approx. 7,000V
0.01ppm or less (Note 2) (Note 3)
0.5MPa
Air (dried clean air) (Note 6)
For storage: -10 to +65°C
35 to 65%RH. For storage: 35 to 85%RH
2
(approx. 10G), 3 times in each of XYZ directions (when the power is off)
Floating
Main unit enclosure: PPS, Stainless steal (SUS).
Head mounting bracket: Stainless steal (SUS).
Discharge needle: PFA, PC, PPS, Tungsten (Note 8).
0.5m
0.5m (Note 9）
Approx.
Approx.
Approx.
Approx.
330g
410g
530g
650g
Controller
ER-XC02
Maximum 2 units
24V DC±10%
450mA or less when connecting 1 heads.
800mA or less when connecting 2 heads.
Displays status of Head 1 and 2
PhotoMOS relay output
• Maximum load current: 100mA
• Applied voltage: 30VDC or less (between output-output common)
• Residual voltage: 1.5V or less (at load current of 100mA)
Equipped (automatic reset type)
Photo coupler input
・Input current: 4.5mA or less
・Input voltage: 30VDC or less (between input-input common)
・Input impedance: about 7kΩ.
2
35 to 65%RH. For storage: 35 to 85%RH
2,000 m or less (Note 1)
AC 500V, 1 minute, charged part/between F.G.
(when power is off)
2
(approx. 10G), 3 times in each of XYZ directions (when the power is off)
I
Floating
Enclosure: ABS
Approx. 130g
Head connection cable
ER-XCCJ5H
ER-XCCJ10H
5m
Cabtyre cable with connectors at both ends
Approx. 290g
ER-X008
ER-X016
ER-X032
ER-X048
ER-XANT
－
ER-XACVR
ER-XAPS-EX
ER-XCC2 (2m)，ER-XCC5 (5m)
16
DIMENSIONS (Unit: mm)
<Head part>
● Head
ER-X064
28.5
640mm
9.4
2-6.5
Approx.
● High-voltage unit
780g
2-6.5 Mounting holes
38
(18)
<Controller>
<Head connection cable>
10m
Approx. 560g
ER-X064
http://panasonic.net/id/pidsx/global
Overseas Sales Division (Head Office)
2431-1 Ushiyama-cho, Kasugai-shi, Aichi, 486-0901, Japan
Phone: +81-568-33-7861 FAX: +81-568-33-8591
For sales network, please visit our website.
PRINTED IN JAPAN
※ Please refer to the instruction manual of the head part for the form dimensions of ER-X001.
B
40
A
40
(E)
D
C
Model No.
ER-X008
A
40
B
106
C
138
D
150
163
(E)
6.2
6
180
17
160
2-4.5 Mounting holes
10.5
170
162
192
35 mm wide DIN rail
(103.5)
7
(9.1)
(9.1)
© Panasonic Industrial Devices SUNX Co., Ltd. 2017
28.5
9.4
22
18
ER-X016
ER-X032
ER-X048
ER-X064
120
280
440
600
194
354
514
674
226
386
546
706
238
398
558
718
251
411
571
731
High-voltage cable ø6.9
31
(16) (16)
For head 1
For head 2
Head connection
connector
S12B-PUDSS-1
[Manufactured by
5.2
JST Mfg. Co., Ltd.]
18
53
39
10
7
2-5.0
Mounting
holes
(23.2)
<Power cable>
(19.6)
Advertisement
