In/outlet: 1” BSP male 2. Control Characteristics The BIA-IPRESS is an adjustable digital pump pressure controller. It starts and stops the pump according to the detected water pressure and flow through the pipe. This controller can be used to replace a conventional pressure tank, pressure switch installation.
3. Control Functions Start/Stop pressure can be set Start pressure can be set Start pressure Stop pressure...
Page 5
4. Operating instructions • Setting working parameters Press the Function button (7). The screen will display ‘dE1’ and Flash. ‘dE1’ means the pump is working at its max head. In this mode, only the starting pressure can be adjusted and the pump will stop working at its max head. ‘dE2’...
Page 6
5. Possible Working Defects Type of Possible cause related to unit Possible cause not related to unit defect The pump The controller is The voltage is lower than 240V does not start damaged The pump is no longer working The restart button is Electric cabled inverted jammed (Line/motor)
Page 7
7. Warning • The controller must not be used in the medical industry or any system which will cause serious personal injury or property damage in the event of a failure. • The controller itself has no spare parts supplied to the purchaser and must be maintained by a suitably qualified professional.
12 MONTH WARRANTY White International Pty Ltd Limited Product Warranties TERMS & CONDITIONS This warranty is given in addition to the consumer guarantees found within the Australian Competition and Consumer Act 2010 (Cth) for goods purchased in Australia and the Consumer Guarantees Act 1993 NZ for goods purchased in New Zealand: White International Pty Ltd / White International NZ Ltd (White International) warrant that all products distributed are free from defects in workmanship...
Page 9
12 MONTH WARRANTY cont. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
Need help?
Do you have a question about the BIA-iPRESS and is the answer not in the manual?
Questions and answers