Advertisement
Installation Guide
Installing and Using an ME906s Module
1.
Connect an antenna connector to the antenna interface of an ME906s.
Note:
Insert the antenna connectors vertically into the antenna interfaces of the ME906s.
Do not pinch the antenna cable or damage the connectors. Otherwise, the wireless
performance of the ME906s be reduced or the ME906s cannot work normally.
Ensure that the antenna is placed normally.
2.
Fasten the golden finger in the ME906s module to a M.2 connector of a development board to
fix the ME906s module on the development board.
3.
Place a metal fastener between the ME906s module and the development board. Put a screw
through the fixing hole of the ME906s, metal fastener, and fixing hole of the development
board in sequence. Then fasten a nut on the screw.
4.
Insert a UIM card into the UIM card socket in the development board.
Removing an ME906s Module from a Development Board
1.
Remove the UIM card from the UIM card socket.
2.
Power off
3.
Remove the screw on the ME906s module.
4.
Remove the ME906s module from the development board.
5.
Remove the antenna from the ME906s module.
4
Advertisement
