Table of Contents
Advertisement
Installing Cables
● Connecting optical fibers
1. The right figure shows the appearance of the optical fiber：
2. The optical fiber connection of AP6610DN-AGN-US is similar to that of WA653SN. Here, WA653SN is used as an
example. Connect the optical fiber to the AP and ensure that the waterproof connector is fastened.
a
b
CAUTION
The thread must be secured properly; otherwise, optical fibers may be damaged. When removing optical fibers, remove the
waterproof PG connector, and then remove the optical fiber connected to the AP. When removing the waterproof PG
connector, use the ejector lever to clutch the optical fiber tube. This prevents the optical fiber tube from rotating with the
waterproof PG connector and protects optical fibers.
● Connecting AC power cables
1. Make an AC power cable onsite, cut the cable of proper length. Make a cable according to figure 1. L/N/PE pin
arrangement must be correct.
2. When connecting the AC power cable to the AP, align the socket to the red point of the connector, and insert the
waterproof connector. When a crack sound is heard, the AC power cable is installed properly. When removing the AC
power cable, press the component with the red point. You do not need loosen the screw.
Figure 1
● Making AC Power Cables Onsite
a Preparation
1. The required tools are as follows: open-end wrench
(22mmX24mm), open-end wrench (22mmX24mm), Phillips
screwdriver (0#X50mm), diagonal pliers, and utility knife.
b Connection
1. Use cable ties to fasten the cable, remove the socket
and nut together, and then lead the cable through the socket
and nut.
Wiring
terminal
Cable tie
d
c
b
c
e
f
Install an optical module as shown in step a
before connecting the fiber.
d
2. The following table shows the connector components.
2. Strip the cable.
Cable
CAUTION
Be careful when striping the cable, please don't damage
the Core wire and the Conductor.
7
NOTE
e
f
Figure 2
Shell
Screw
Socket
Core wire Conductor
Nut
Advertisement
Table of Contents
