Operation - Belkin P73220uk User Manual

CAUTION:
wiring during a lightning storm.
5.6 Charge the Battery
The UPS charges its battery
whenever it is connected to the
utility power. For best results,
charge the battery for 4 hours
prior to initial use.
5.7 Cable Management
It is used to corral all of the power cords into a neat and safe order. It also assists in
preventing accidental cord detachment.
CAUTION: The cable management rail should not be used as a handle.
Attempting to lift the UPS by the cable management rail could result in
personal injury and/or damage to the UPS.
6.0 Switch On
With the UPS plugged in, press and hold the on/off/test button
until the "ON LINE"
each time it is switched on. The "ONLINE "
power to the connected loads. The UPS can be utilised as a master on off switch for the
protected equipment.
NOTE: The UPS maintains the battery charge when in the off position and will respond to
commands received through the computer interface port.
6.1 Switch Off
Press and hold the on/off/test button
or "ON BATTERY"
6.2 SELF-TEST
Use the self-test to verify both the operation of the UPS and the condition of the battery.
In normal utility power, push the on/off/test button
performs a self-test function. During the self-test, the UPS operates in back-up mode.
NOTE: During the self-test, the UPS briefly operates the loads on-battery
audible alarm beeps at 15 second intervals. If the UPS passes the self-test, it returns to
on-line operation.
6.3 SILENCE
In " BACK-UP" mode, push the on/off/test button
audible alarm. (The function is void when under condition of "LOW BATTERY"
or "OVERLOAD"
Installation
This surge protection device is for indoor use only. Never install telephone
LED lights up to switch the UPS on. The UPS will perform self-testing
LED goes off.
.)
(continued)

Operation

LED remains on when the UPS is supplying
for more than 3 seconds until the "ON LINE"
10
for more than 3 seconds
less than 1 second and the UPS
less than 3 seconds to silence the
and the