Checking And Replacing Blades - Kubota Z411 Operator's Manual

PERIODIC SERVICE
• Apply the parking brake.
• Stop the engine and remove the key before
replacing fuses.
1. Raise the operator's seat.
2. Remove the blown fuse.
3. Place a new fuse of the same capacity in position.
(1) Fuse location
(2) Slow blow fuse (under red
tape)
IMPORTANT :
• If the new fuse happens to blow out within a
short time, contact
inspection and repair. Never "jump" the fuse
with wire or foil, or install a larger capacity
fuse than recommended.
68
your dealer for
Capacity
Fuse no.
(A)
7.5
7.5
(1)
10
Slow blow fuse
(2)
30

2. Checking and replacing blades

WARNING
To avoid serious injury or death:
• Be sure to stop the engine and remove the key.
• Blades may be sharp. When you handle blades,
wear heavy gloves or wrap the end of the
blades with a rag.
NOTE :
• Before checking or replacing the blades, wipe
grass and mud off the top and inside of the
mower.
Especially, clean
otherwise the belt life will be reduced.
Checking
The blade cutting edges should be kept sharp at all
times. Sharpen the cutting edges if they look like blade
(B). Replace the blades if they appear similar to blade
(C).
(A) New blade
(B) Worn blade
Replacing
1. Dismount the mower deck from the machine.
(See DISMOUNTING THE MOWER DECK on page
25.)
SERVICE AS REQUIRED
Protected circuit
Start
3 Operator control
PTO clutch
Accessories
- -
- -
Check circuit against
wrong battery connec-
tion
inside the belt
(C) Cracked blade
cover,
Z400