Bosch PLR 30 C Original Instructions Manual page 25

Digital laser measure
Bluetooth®
Operating frequency band
Max. transmission power
A) For measurements from the rear edge of the measuring tool. The working range increases de-
pending on how well the laser light is reflected from the surface of the target (scattered, not re-
flective) and the brighter the laser point is to the ambient light intensity (interior spaces, twi-
light). For distances of less than 20 m, a retro-reflective target plate should not be used, as it
can lead to measurement errors.
B) For measurements from the rear edge of the measuring tool, 100% reflectivity of the target (e.g.
a white wall), weak backlighting and 25 °C operating temperature. In addition, a deviation influ-
ence of ±0.05 mm/m needs to be taken into account.
C) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by
condensation is expected.
D) depending on surface characteristics and ambient conditions
E) At an operating temperature of 25 °C
F) Bluetooth® deactivated
G) When using Bluetooth® Low Energy devices, it may not be possible to establish a connection de-
pending on the model and operating system. Bluetooth® devices must support the SPP profile.
The serial number (11) on the type plate is used to clearly identify your measuring tool.
Fitting
Inserting/changing the batteries
It is recommended that you use alkaline manganese batteries to operate the measuring
tool.
Note that if you use 1.2 V batteries, you will not be able to perform as many measure-
ments as you would with 1.5 V batteries.
Push the locking mechanism (10) in the direction of the arrow to open the battery com-
partment cover (9) and remove the battery compartment cover. Insert the batteries.
When inserting, pay attention to the correct polarity according to the representation on
the inside of the battery compartment.
When the battery symbol
100 measurements can be taken. Once the battery symbol is empty, you have to replace
the batteries/rechargeable batteries, because measurements are no longer possible.
Bosch Power Tools
Bluetooth® 4.0
(Classic and Low En-
2402–2480 MHz
appears on the display for the first time, at least another
English | 25
PLR 30 C PLR 40 C
Bluetooth® 4.0
(Classic and Low En-
G)
ergy)
2402–2480 MHz
2.5 mW 2.5 mW
1 609 92A 4P0 | (18.01.2019)
G)
ergy)