Advertisement
If you are attaching the antenna to a marine extension mast or rail mount:
Step 1: Route the 6" cable from the antenna through the thread adapter.
Step 2: Screw the antenna onto the thread adapter.
Step 3: Route the 25' (or optional) cable through the extension mast or rail mount.
Step 4: Attach the 25' cable's connector to the connector on the 6" antenna cable.
Step 5: Screw the antenna assembly onto the extension mast or rail mount. IMPORTANT:
Rotate the cable counterclockwise while turning the antenna assembly clockwise. Make sure
the cable turns freely and does not bind.
SPECIAL NOTE: The hole in ratchet-type antenna mounts will not accommodate the
SRA-40's connector. You must use the included flange mount, a rail mount, or an extension mast,
which will allow the cable and its connector to pass through. Do not cut the cable and do not
remove the connector.
Skip to "Completing the installation," below.
Step 1: Route the cable to your satellite radio receiver.
IMPORTANT: If your satellite receiver has two antenna input terminals, the optional SRS-1
Splitter may be required. Newer models may differ, so consult your dealer or Shakespeare for up-
to-date information.
Step 2: Attach the SMB connector to your satellite radio receiver. See the receiver's manual
for precautions and instructions. Done!
EXTENSION MAST OR RAIL MOUNTING
Completing the installation
Advertisement
