Sirius Satellite Radio SIRIUS InV2 User Manual page 46

Step 2: Prepare the FEA for temporary installation
Attach the suction cups to the antenna portion of the FEA in the positions shown in
Figure 24. The antenna portion of the FEA is the relatively thinner section of the cable
in between the bead and the arrow that transmits the FM signal to your vehicle's FM
antenna.
ATTACH SUCTION CUPS AS SHOWN ANTENNA CONNECTS TO YOUR SIRIUS
ON BOTH ENDS OF THE THIN WIRE CABLE VEHICLE DOCK'S FM OUT
ARROW BEAD
CONNECTOR
THIS THINNER PORTION OF THE FEA IS DURING THE FINAL INSTALLATION USE THE CABLE
WHAT TRANSMITS THE FM SIGNAL TO
GUIDES TO HOLD THE CABLE IN POSITION UNTIL
YOUR VEHICLE'S FM ANTENNA
IT REACHES THE INNER TRIM OR MOULDING
Figure 24
Step 3: Use the suction cups to temporarily install the FEA according to your
vehicle's antenna type
On the next several pages you will find the FEA mounting location for your type of FM
antenna (A, B, C, etc.). Before attaching the FEA, clean the area where the suction
cups will be mounted with the supplied alcohol swab. The FEA wire between the two
suction cups should be pulled taut and as straight as possible, and should not obstruct
the driver's view.
[ ]
46
Installation