Download  Print this page

Precautions; Safety Precautions; Warnings; Servicing The Led Tv - Samsung UE32H6200AW Service Manual

Chassis u8dc.
Hide thumbs

Advertisement

1. Precautions

1-1. Safety Precautions

Follow these safety, servicing and ESD precautions to prevent damage and to protect against potential hazards such as
electrical shock.

1-1-1. Warnings

For continued safety, do not attempt to modify the circuit board.
Disconnect the AC power and DC power jack before servicing.
WARNING

1-1-2. Servicing the LED TV

1.
When servicing the LED TV, Disconnect the AC line cord from the AC outlet.
2.
It is essential that service technicians have an accurate voltage meter available at all times. Check the calibration of this
meter periodically.

1-1-3. Fire and Shock Hazard

Before returning the monitor to the user, perform the following safety checks:
1.
Inspect each lead dress to make certain that the leads are not pinched or that hardware is not lodged between the
chassis and other metal parts in the monitor.
2.
Inspect all protective devices such as nonmetallic control knobs, insulating materials, cabinet backs, adjustment and
compartment covers or shields, isolation resistorcapacitor networks, mechanical insulators, etc.
3.
Leakage Current Hot Check:
(READING SHOULD)
NOT BE ABOVE 0.5mA
DEVICE
UNDER
TEST
2-WIRE CORD
ALSO TEST WITH
PLUG REVERSED
(USING AC ADAPTER
PLUG AS REQUIRED)
Do not use an isolation transformer during this test.
Use a leakage current tester or a metering system that complies with American National Standards
Institute (ANSI C101.1, Leakage Current for Appliances), and Underwriters Laboratories (UL
WARNING
Publication UL1410, 59.7).
4.
With the unit completely reassembled, plug the AC line cord directly into a 120V AC outlet. With the unit's AC switch first
in the ON position and then OFF, measure the current between a known earth ground (metal water pipe, conduit, etc.)
and all exposed metal parts, including: metal cabinets, screwheads and control shafts.
The current measured should not exceed 0.5 milliamp.
Reverse the power-plug prongs in the AC outlet and repeat the test.
LEAKAGE
CURRENT
TESTER
TEST ALL
EXPOSED METAL
SURFACES
EARTH
GROUND
1. Precautions
1-1

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: