Counterfeit Detection Modes - Semacon S-1100 Series Operating Manual

Counterfeit Detection Modes

UV Counterfeit Detection Feature (models S-1115 and S-1125 only)
Press the UV button and "Uv" will appear in the Batch Setting Display followed by a number from 1-5. The
"Uv" signifies the Ultraviolet Counterfeit Detection feature and the number indicates the Ultraviolet
Counterfeit Detection setting. "1" is the lowest detection level and "5" is the highest detection level. To
change the detection level, continue pressing the UV button. When you stop pressing the button, the unit will
save the setting after a few seconds and then return to the standby (ready) mode. The UV indicator light will
be on when the Ultraviolet Counterfeit Detection system is active. Continue to press the UV button to turn the
feature and indicator light off.
NOTE: The factory setting for the UV Counterfeit Detection feature is 3. If you get too many false UV
errors, lower the sensitivity setting to reduce the potential for false suspect notes.
MG Counterfeit Detection Feature (model S-1125 only)
Press the MG button and "ng" will appear in the Batch Setting Display followed by a number from 1-5. The
"ng" signifies the Magnetic Counterfeit Detection feature and the number indicates the Magnetic Counterfeit
Detection setting. "1" is the lowest detection level and "5" is the highest detection level. To change the
detection level, continue pressing the MG button. When you stop pressing the button, the unit will save the
setting after a few seconds and then return to the standby (ready) mode. The MG indicator light will be on
when the Magnetic Counterfeit Detection system is active. Continue to press the MG button to turn the
feature and indicator light off.
NOTE: The factory setting for the MG Counterfeit Detection feature is 2. If you get too many false MG
errors, lower the sensitivity setting to reduce the potential for false suspect notes.
9