Mechanical Drive Installation; Disassemble The Mechanical Drive Spline Assembly; Remove The Steering Wheel - Raven RS1 MD Installation Manual

CHAPTER
3
NOTE: The installation instructions contained in this manual may vary slightly from the steps required to
install RS1 MD on various machine models.

DISASSEMBLE THE MECHANICAL DRIVE SPLINE ASSEMBLY

FIGURE 1. Spline Assembly Disassembled
1. Locate the spline adapter assembly (P/N 063-4001-014 or 063-4001-015).
2. Disassemble the spline adapter assembly as shown in Figure 1 above.

REMOVE THE STEERING WHEEL

NOTE: The steps in this section require use of a steering wheel puller (not supplied). For questions on the
proper procedure for removing the steering wheel, contact your local equipment dealer.
P/N 016-5030-200 Rev. A
M ECHANICAL DRIVE
C H A P T E R 3
INSTALLATION
Nut
Male Spline
Adapter
Washer
Female Spline
Adapter
Bolts
11