Igniter Replacement - Sengoku Mega-23K Owner's Manual

(28) Reinstall the heater body and tighten 4 screws.
(29) Replace the burner into the body making sure to follow the instructions on the burner, "this side
up".
(30) Reinstall top plate.
(31) Reinstall top guard and fasten 2 securing screws.
Install the batteries in the battery case. Fill with clean, pure 1-K kerosene. Wait at least 60 minutes
for kerosene to fully saturate the new wick. IMPORTANT ! If this is not done air bubbles may form
in the wick reducing its ability to draw up kerosene.
Remember to "dry burn" the new wick after each 5 or 6 tankfulls of kerosene are consumed.
(fig.18)
AFTER THE ASSEMBLY IS IN
PLACE, ROTATE 90
RIGHT AS WELL AS UP AND
DOWN UNTIL THE WICK
SLIDES FREELY
NOTE: Wick height is measured from top rim of the wick adjuster. The wick
height should be 25/64 in. (10 mm).
X. IGNITER REPLACEMENT
Be sure igniter is 2.5V DC, 1A only.
(A) Remove batteries from case.
(B) Remove the top guard, top plate, body and burner.
(C) Push the igniter knob. To remove the igniter, push
in and turn counterclockwise. Install new igniter and
reassemble the heater. Then install batteries.(fig.21)
REMOVE OLD WICK
WICK ADJUSTER
FOLD IN
WICK TO
REMOVE
゜
LEFT AND
PENDULUM ON
TIP OVER SWITCH
INSTALL NEW WICK
UNFOLD
WICK
BLACK
LINE
RIM OF
WICK
ADJUSTER
(fig.19)
Igniter
9
- -
7/32 IN. (5.7 mm) All around
WICK 25/64 IN. (10 mm)
(fig.20)
(fig.21)