Advertisement
TROUBLE SHOOTING
If any connection procedure is struggling the easiest solution is to factory reset. This clears any
history/memory to enable a fresh start. However, USER Programs and Remote settings will still
be maintained.
If the
button flashes red unexpectedly it may have lost its connection to its light. The solution
A
is to press the function button once on the light, this may reconnect them. If this is unsuccessful,
press the
button 4 times to go to sleep. Reconnect after sleep mode as normal.
B
FACTORY RESET - LIGHT
Diablo - Press and hold the function button for approximately 12 seconds, in that time it will multi
flash and then count through 12 flashes, (the rear LED will also flash red/green), release. The rear
LED will flash once, green to confirm.
Bar Lights – Press and hold the function button until PGM 1 appears on the screen, release.
Without delay Press the function button a further 11 times to enter PGM 12, the screen will then
show RESET for 1 second.
REAR LED
FUNCTION
BUTTON
FUNCTION
BUTTON
Advertisement
