Advertisement
Basic Usage
1.
2.
Pull the spring lock to open the front door.
3.
Place the HDD into EMK3102 with its printed label up-sided.
4.
Press the door to push the hard drive into EMK3102 until the door is locked.
Attach the included mylar film as shown.
Unload the
Hard drive
1. Smoothly pull the spring lock to open the door. Make sure the key lock
is on a removable position, or the lock would get damaged.
2. Carefully take the hard drive out from EMK3102.
Attention
1. To perform hot-swap function, the host must also support hot-swap.
2. Keep the device out of high temperature and humid environment.
3. If the device or HDD is damaged due to improper operation, we would not take the
responsibility of compensation or repair.
User manual
EMK3102
Advertisement
Table of Contents
Related Manuals for ENERMAX EMK3102
Summary of Contents for ENERMAX EMK3102
- Page 1 Pull the spring lock to open the front door. EMK3102 Place the HDD into EMK3102 with its printed label up-sided. Press the door to push the hard drive into EMK3102 until the door is locked.
- Page 2 SATA 15 pin to 4 + 4 pin Power Cable 4 Insert EMK3102 into the bay and align the screw holes. Screws Screw the EMK3102 with 2 screws of each side to securely hold the device. IInsulating pad User manual...
Need help?
Do you have a question about the EMK3102 and is the answer not in the manual?
Questions and answers