Panasonic WV-Q122A Operating Instructions Manual page 8

[2] Attaching the mount bracket
The installation of the wall mount bracket is roughly divided into 2 methods.
Refer to the applicable description.
■ When laying cables through the cable access hole (front) (
■ When laying cables after drilling a hole through the wall (
■ When laying cables through the cable access hole (front)
Step 1
Decide the mounting position and drill a hole in the wall.
Procure 4 pieces of M10 screws and anchors to secure the
this bracket on the wall.
All screws and anchors shall be stainless steel. The hole
diameter shall be decided in accordance with the screws
and anchors to be used.
A hole on the wall with a diameter of 30 mm {ø1-3/16
inches} or less can be hidden with this bracket.
{3-5/32 inches}
8
80 mm
☞
8 page)
☞
10 page)
Step 2
Make a slit in the center of the cable cap (accessory) with a
cutter.
Step 3
Pass the cables from the housing base through this
bracket, and mount the cable cap that was slit in Step 2 on
the cable access hole (front).
Secure the housing base to the wall mount bracket.
Attach the housing base to this bracket using the 4 screws*
supplied with the camera. The "REAR" mark of the housing
base shall be directed to the wire hook section.
* Refer to the Operating Instructions of the camera for the
screws and the wrenches to be used, which depends on
models.
For the case of the camera with M5 screws being used
(WV-SW598): Use the screws supplied with the camera
and a hexagonal wrench "for M5".
Wire hook
section
Cable access
hole (front)