Changing The Filter; Led Lighting - Kenmore 970F44853 Series Use & Care Manual

Changing the Filter

Air Filter
The air filter is located inside one of the
2-Liter Door Bins. The air filter cover is
located on the upper right side of the
control box. In general, you should change
the air filter with Part Number "PAULTRA"
every 6 months to ensure optimal filtering
of appliance odors. The electronic control is
equipped with a Change Filter Indicator to
remind you to change your filter. To reset the
"Change Filter Indicator Light" hold the air
filter button until the light changes.
To Install Or Replace The Air Filter
• Pull down on the front of the air filter
cover to release the hinged bottom cover.
• Allow bottom cover to swing open and
then remove the old filter and discard it.
• Unpackage the new filter and place it
inside the hinged bottom cover of the
housing.
• Push the hinged bottom cover upward
until the tab snaps into closed position.
Open Air Filter Cover
Remove Air Filter

LED Lighting

Replacing LED Lights (select models)
To Replace LED Lights:
1. Unplug the power cord.
2. Remove light cover by pushing up
and out.
3. Hold the LED cover with one hand and
pull the connector with the other hand
while pressing the connector latch.
4. Replace LED light and snap in place
assuring the light is facing in toward
the unit (inside fresh food).
LED Light Removal
LED Light Harness Removal
NOTE
LED lights are in series, so if one is bad or
unplugged, several lights may not light up.
14