Advertisement
Replace the collet nut and tighten the collet nut. Release the spindle
lock button.
CAUTION! Always Unplug from the tool and switch off before
replacing the collet; Choose a low speed at first for working.; Never
press the locking pin while the machine is running
Polishing. A polishing wheel is set for polishing metal and plastic
workpieces. A mandrel is used for mounting a polishing wheel.
Place the mandrel in the collet nut Place a polishing wheel on the
screw.
Rouging. A router bit is used for grooving and for routing figures in
plastic, wooden and metal workpieces. Place a router bit in the collet
nut.
Grinding and sanding. A grinding stone in used for grinding metal,
plastic, wooden and the stone workpieces, A sanding band is used
for sanding wooden and plastic workpieces. Place a grinding stone
or sanding band with mandrel in the collet nut. A sanding band must
be replaced when showing signs of wear Remove the old sanding
band from the mandrel. Place the new sanding band on the mandrel
Clamp all tolls as short as possible, Shafts, which stick out too far
will easily bend causing the machine to vibrate.
Maintenance
CAUTION: Pull out the plug before maintenance
Keep the machine clean
Keep the air vent unimpeded
Do not use the sharp material to clean the machine
Do not let liquid enter into the machine to prevent it from rust
HAVE YOUR POWER TOOL SERVICED BY A QUALIFIED
REPAIR PERSON USING ONLY IDENTICAL REPLACEMENT
PARTS. THIS WILL ENSURE THAT
THE SAFETY OF THE POWER
TOOL IS MAINTAINED.
PT-5201 輕便型電磨組操作手冊
產品組合
1. 夾套螺母 2. 主軸鎖定鍵
3. 開關
4. 電源線
注意!
使用設備前，請仔細閱讀本手冊中的說明以及一般的安全指示。熟練掌握操作
規範，各種膠袋不應該放置在兒童觸及到的地方，以免引起窒息的風險。
4
Advertisement
