Advertisement
have them repaired by an authorized service facility. Inspect
extension cords periodically and replace if damaged. Keep
Handles dry, clean and free from oil and grease.
15. Disconnect tools when not in use, before servicing, and when
changing accessories such as blades, bits and cutters.
16. Remove adjusting keys and wrenches. From the habit of
checking to see that keys and adjusting wrenches are removed
from tool before switching it on.
17. Avoid unintentional starting. Do not carry plugged-in tools
with finger on switch. Be sure the tool is switched off before
plugging in.
18. Outdoor use extension cords. When tool is used outdoors,
use only extension cords intended for use outdoors and so
marked.
19. Stay alert. Watch what you are doing. Use common sense. Do
not operate tool when you are tired.
20. Check damaged parts. Before further use of the tool, a guard
or other part that is damaged should be carefully checked to
determine that will operate properly and perform its intended
function. Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other conditions
that may affect its operation. A guard or other part that is
damaged should be properly repaired or re placed by an
authorized service center unless otherwise indicated elsewhere
in the instruction manual. Do not use tool if switch does not turn
it on and off.
21. Warning! The use of any other accessories or attachment other
than recommended in the instruction manual may present a risk
of personal injury.
22. Have your tool repaired by an expert.This electric appliance is
built accordance with the relevant safety rules. Repair of electric
appliances must only be carried out by experts otherwise it may
cause considerable danger for the user.
23. Store these instructions for future reference.
Assembly and operation
Mounting an accessory
Keep the spindle lock button depressed. Slacken the collect nut.
Insert the shaft of the accessory into the collet.tighten the collet nut.
Release the spindle lock button in order to remove the accessory,
proceed in reverse order.
Replacing the collet
Keep the spindle lock button depressed. Slacken the collet nut.
Remove the collet nut and the old collet. Place the new collet in.
3
Advertisement
