Electric Windows - Alfa Romeo Giulietta Owner's Handbook Manual

ELECTRIC WINDOWS

These operate when the ignition key is
turned to MAR and for about 3 minutes
after turning the key to STOP or
removing it if one of the front doors is
open.
The buttons are located in the door panel
trim fig. 25 (the driver side door panel
can be used to operate all the windows).
Anti-crush safety device
An anti-pinch device operates when the
front and rear windows are raised. This
safety system detects the presence of an
obstacle during the window closing travel
and cuts in by stopping and reversing the
window travel, depending on its position.
13)
26
CONTROLS
Driver side front door
25
1: opening/closing front left window;
"continuous automatic" operation during
window opening/closing stage;
2: opening/closing front right window;
"continuous automatic" operation during
window opening/closing stage;
3: opening/closing rear right window
(for versions/markets, where provided);
"continuous automatic" operation during
window opening/closing stage.
4: opening/closing rear left window
(for versions/markets, where provided);
"continuous automatic" operation during
window opening/closing stage;
5: enabling/disabling of rear door
electric window controls;
Front passenger door
There is an open/close button with
"continuous automatic" operation on the
passenger side for the relative window.
Electric window system initialisation
The system must be re-initialised after
disconnecting the battery or if the
relevant protection fuse is blown.
Initialisation procedure:
fully close the window to initialise
manually;
after the window has reached the
A0K0581C
upper end of travel, hold the up button
pressed for at least one second.
For versions/markets where provided,
after there has been no power supply for
the control units (battery replaced or
disconnected or protection fuses for the
electric window control units replaced),
the automatic operation of the windows
must be restored.
The restoration procedure must be
performed as described below with the
doors closed:
completely open the driver's door
window keeping the operating button
pressed for at least three seconds after
the (lower) end of travel position is
reached;
completely raise the driver side
window and hold the button down for at
least 3 seconds once the (upper) end of
travel position has been reached;